Laue Diagram Simulator & Indexer

Set Analysis Solutions Orient

Lattice

Lattice Parameters

a (Å)

b (Å)

c (Å)

α (°)

β (°)

γ (°)

X-Ray Source (Laue)

λ_min (Å) λ_max (Å)

Detector Geometry

Angle (°) (0=Trans, 180=Back)

Dist. (mm)

Goniometer Rotation (°)

Represents the physical goniometer controls, relative to the orientation found in the 'Analysis' tab.

X: Y: Z:

Load Image

Invert Image

Show Spots

Set Scale

Move the blue dot to a known reference point. Then enter its coordinates relative to the center.

U (mm) V (mm)

Experimental Peaks (U, V)

Run a search from the "Analysis" tab to see solutions here.

Orient to (h,k,l)

Align a specific (h,k,l) plane parallel to the detector.

Required Goniometer Angles (°)

Note

This calculates the goniometer angles (in the 'Set' tab) required to rotate from the *current base orientation* to the new target.

• The (h,k,l) plane is parallel to the detector. A (h,k,l) spot will only be visible if its required wavelength is within the "X-Ray Source" range specified in the 'Set' tab.

Please load an image to begin.