Physical goniometer controls, relative to the orientation selected in the 'Search' tab.
Lattice Parameters
No file loaded.
Set Scale
Move the blue dot to a known reference point. Then enter its coordinates relative to the center.
Experimental Peaks (U, V)
Load an image, set center and scale, and add at least 4 peaks to enable search.
Solutions
Run a search to see solutions here.
Select a solution in the "Search" tab first to enable orienting to a target (h,k,l).
Orient to (h,k,l)
Align a specific (h,k,l) plane parallel to the detector.
Required Goniometer Angles (°)
Note
This calculates the goniometer angles (in the 'System' tab) required to rotate from the currently selected solution's orientation to the new target. Angles are only applied to the goniometer once you press "Set Orientation".
• The (h,k,l) plane is parallel to the detector. A (h,k,l) spot will only be visible if its required wavelength is within the "X-Ray Source" range specified in the 'System' tab.